- Joined
- Mar 10, 2016
- Messages
- 1,635
Here's my camera arm and base. The base is 5 inch 6061 aluminum U channel and some camera rig parts with a piece of drilled out HDPE for the arm to drop into.
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/360920845194
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/281430274528
The carbon arm is 25mm tubes. 7/8ths pvc should technically squeeze inside the carbon.... It doesn't, so I had to scrape it down and cut 4 pieces at 1.5". I drilled a 1" whole into a black HDPE block and cut it up for the washers and tripod head mount. 3/8ths aluminum rod just pressed into the pvc for the swivel. And a 3/8-16 Allen set screw jb welded in for the video head. Make sense? Let me know if you want close up or have questions.
25mm Carbon Fiber Tube 25mmx22mmx330mm 3K roll Wrapped Twill Matte Surface(2 pcs) https://www.amazon.com/dp/B07BCYFRKR/ref=cm_sw_r_cp_apa_YIESBbMFXEV28
PVC (Polyvinyl Chloride)... https://www.amazon.com/dp/B0013HQ93Q?ref=yo_pop_ma_swf
Sent from my moto z3 using Tapatalk
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/360920845194
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/281430274528
The carbon arm is 25mm tubes. 7/8ths pvc should technically squeeze inside the carbon.... It doesn't, so I had to scrape it down and cut 4 pieces at 1.5". I drilled a 1" whole into a black HDPE block and cut it up for the washers and tripod head mount. 3/8ths aluminum rod just pressed into the pvc for the swivel. And a 3/8-16 Allen set screw jb welded in for the video head. Make sense? Let me know if you want close up or have questions.
25mm Carbon Fiber Tube 25mmx22mmx330mm 3K roll Wrapped Twill Matte Surface(2 pcs) https://www.amazon.com/dp/B07BCYFRKR/ref=cm_sw_r_cp_apa_YIESBbMFXEV28
PVC (Polyvinyl Chloride)... https://www.amazon.com/dp/B0013HQ93Q?ref=yo_pop_ma_swf
Sent from my moto z3 using Tapatalk