- Joined
- Nov 1, 2018
- Messages
- 8,014
PictureOkay… so a couple months ago I hacked 6” off a gen3 one stick. Used a pipe cutter to cut 6” off the bottom. Pressed the pin out and beat the plug out. Drilled a new hole for the rollpin. Rolled the edge of the tube very slightly and beat the plug back in. Added another containment button to have them on both steps as a safeguard to prevent the rollpin from walking out. I did this on all my one sticks for piece of mind. Holding up just fine. No wobble. The stick with my 2 step ultimaider and stealth stripped weighs 1lb 6oz. I plan on making an aider from 3/4” webbing when I get around to it. For now this works just fine.