- Joined
- Aug 14, 2019
- Messages
- 1,204
Mack's out of stock!!
and the maraca issue and packaging, as well as the suction cups issue. MAKE SURE YOU HAND TIGHTEN THE SUCTION CUPS. if you crank to hard you will ruin them
Dave T method to stack
Bought a single regular Helium back in April to try out one sticking, and the stick itself was twisted from the middle of the stick to the bottom. No way in hell I’d give Hawk anymore of my money after reading the issues people are having with the 20” sticks.
Sent from my iPhone using Tapatalk
i like that set up. one thing i like about the suction cups is you can take them off one at a time and the others are still together, Genesis 3d clips seem like an easy solution also but cost a little more $$Here is the video describing these, check his channel, he's got three more videos on the Helium sticks, but this is the most recent:
What exactly is this rattle slag? Chips from drilling? Slag on aluminum is made from plasma cutting. I never seen the helium in person so I'm just trying to figure what u guys are talking about
Slag and filings from when they punched or drilled the holes, mine were full of the crap, reminded me of when I was kid and had bb guns full of bbs, I completely removed every bolt and nut from the center tube section of the sticks and drilled out the end tubes and dumped all the stuff out, or you could just use a punch probably or long old screw driver with a rubber mallet, I can’t remember exactly but I made a thread here about it at the time, there quiet now, anybody with this problem shine a flashlight down the hollow end tubes and you will see the problem, knock or drill that little flap of aluminum blocking the stuff from dumping out and remember to remove every bolt from that center hollow tube before attempting it otherwise there will be crap trapped between the bolts in the there.If I had to guess that is the sanding media from when they put the pieces in the big tumber/agitator during the sanding process