What was the result?Well the paracord was a bust.
What was the result?Well the paracord was a bust.
ugh...i was just about to try that tomorrow. What happened?Well the paracord was a bust.
Paracord crushed and bunched up and wouldn't ever release properly. I ended up scrapping the paracord/fuel line idea.What was the result?
By the way, how does one go about disabling a ziptie so that it no longer cinches down? I.e., how do I keep the circle from getting smaller?Paracord crushed and bunched up and wouldn't ever release properly. I ended up scrapping the paracord/fuel line idea.
For me, turns out that a single, loose, plain old ziptie on either side of the tree works perfectly. I left enough room in each of the zipties until there was about a two inch diameter circle (enough to get two fingers into). The ziptie-loop slides over OpLux wonderfully.
View attachment 28565
Fella can never have to much amsteel lying around!
Sweet! A simpler way to do it for sure.Paracord crushed and bunched up and wouldn't ever release properly. I ended up scrapping the paracord/fuel line idea.
For me, turns out that a single, loose, plain old ziptie on either side of the tree works perfectly. I left enough room in each of the zipties until there was about a two inch diameter circle (enough to get two fingers into). The ziptie-loop slides over OpLux wonderfully.
View attachment 28565
How was this working out? I have had two zip ties break, thinking the tie might have been brittle?Paracord crushed and bunched up and wouldn't ever release properly. I ended up scrapping the paracord/fuel line idea.
For me, turns out that a single, loose, plain old ziptie on either side of the tree works perfectly. I left enough room in each of the zipties until there was about a two inch diameter circle (enough to get two fingers into). The ziptie-loop slides over OpLux wonderfully.
View attachment 28565
I'm sorry buddy. Can't speak to how they hold up long-term. I stopped using zip ties when I got some TATs from Genesis 3D Printing.How was this working out? I have had two zip ties break, thinking the tie might have been brittle?
I'm sorry buddy. Can't speak to how they hold up long-term. I stopped using zip ties when I got some TATs from Genesis 3D Printing.
I will say this though... the Austin's tether assist tools are the bees knees!
Interesting. I’d been thinking of making a webbing loop with a water knot and then girthing it the rope.Sewn webbing with a piece of fuel line in it and girth hitched to rope it forms a loop but you got to figure out how long of webbing and fuel line you need. If I can find mine I’ll snap a pic but it’s pretty easy to make and I’m sure you could make this with amsteel
Genesis 3D TATS still going strong. Love that they double as a gears hanger/bow holder.Any updates or new handles?
I try to address my struggles and currently my biggest is moving up my tether. I have a bad shoulder and can barely lift my right arm up, unless I “walk” it up the tree with my fingers. I have some ideas but curious about the latest DIYs. I’m thinking hard wire with looped ends…..I have amsteel, but I’d like to push the tether up instead of pulling it up, if that makes sense.
These work good I made a set last year then I tried my other method. I’m not sure which one I like betterI saw these somewhere. Decided to try and make own… my sewing sucks but it works.
View attachment 61133