Bowhunter41002
Well-Known Member
I was wondering if I could cut the metal d rings off the saddle and put am steel continuous loops in their place.
I was wondering if I could cut the metal d rings off the saddle and put am steel continuous loops in their place.
I was wondering if I could cut the metal d rings off the saddle and put am steel continuous loops in their place.
What kind of utility bridge did u make?I just stealth stripped most of the rings and switched to a DIY utilibridge.
What’s your reason for wanting to get rid of the d rings?
What kind of utility bridge did u make?
You could always sell it and buy a Recon....
Naw...it’s super comfortable and I like everything else about it so I’ll probably keep it... I’m just trying to figure out if I shorten or lengthen the bridge would it keep the d-rings lower? I’m trying to avoid messing with it too much while I’m hunting.You could always sell it and buy a Recon....
Only way to change the position is to change the tether height and your body. Sounds like you have a high tether and or long tether and sitting really low.Naw...it’s super comfortable and I like everything else about it so I’ll probably keep it... I’m just trying to figure out if I shorten or lengthen the bridge would it keep the d-rings lower? I’m trying to avoid messing with it too much while I’m hunting.
I do tend to sit pretty low and kneel against the tree. Tether is about nose height?Only way to change the position is to change the tether height and your body. Sounds like you have a high tether and or long tether and sitting really low.