Figure I’d update this one too since it was my original display of the stick.
Finally got the cam cleat in and installed it today. Only took about 15 min to do.
-Remove versa button
-install set screw
-clamp template to stick
-drill 2 holes
-install cam cleat. (2 bolts, 2 washer, 2 lock washers, and 2 lock nuts)
- tighten until cam cleat binds up and back off barely until springs release.
Found some other #8 bolts that I hope have a little more strength. I also just found grade 8 #8 bolts online. Might have to order them!
Fastenal is the largest fastener distributor in North America. Shop our huge selection of OEM, MRO, construction, industrial, and safety products.
www.fastenal.com
Going to pick up shorter bolts and hoping to figure out a back plate because the washers on the back kept want to slide into the grooves of the shikar.
Here are the pics so far.
This black bolt is the one I found at Ace but forgot to grab washer for the top side under head.
1/4” set screw to fill versa hole. Matt suggested not leaving it hollow.