Hello all… as stated, looking for a little input for getting my Z7 into spec. Had new string put on about 2 years ago, good number of shots since then so I know things stretch. So as expected, last year I had to do a little string/cable twisting to get it back into the timing hole but nothing major. Well, the other day I got to looking it over and checking out the specs and it’s only partially in spec. Timing hole is perfect, but brace height is 1/8 short, axle to axle is about right, 1/16 short, but poundage is fairly low, like 64 on 70# limbs… I have a chart that shows what happens when what is twisted, but some of it will hurt the others worse. As in, if I lengthen brace height, my axle to axle will get even shorter. So I’m kinda stumped on which way is the best route to start. Bow is shooting pretty dang good, so if I need to leave it, then that’s fine, but I’d like to get my poundage back up since I’m already stumpy with a 27” draw. Thanks for any tips!