tarafrost
Well-Known Member
It’s a nite ize figure 9 that I heated a bit and bent the hook inward, then threw some heat shrink tube on.
Can you post a closeup pic of that mod? Thanks!
It’s a nite ize figure 9 that I heated a bit and bent the hook inward, then threw some heat shrink tube on.
Yes, heard itAnother yes. I have the Kong oval from EWO. I put a touch of grease on the threads and it’s quiet now…….you’ll see.
Sorry man I’ve since switched gear hangers and I can’t find it. But here’s a sorta pic of what I did:Can you post a closeup pic of that mod? Thanks!
Yeah I like it. Lotsa folks use a nite ize or gear tie but for me this works well since I leave it tied to my rappel line.@Exhumis do you like the tether locker? I quit using my delta link for everything except final rappel because my line (11.4mm) always wanted to sag a little, that's no good. I thought the ohm might help. Sorry I don't mean to hyjack the thread
@Exhumis do you like the tether locker? I quit using my delta link for everything except final rappel because my line (11.4mm) always wanted to sag a little, that's no good. I thought the ohm might help. Sorry I don't mean to hyjack the thread
Will 9mm canyon elite work with quick link delta? Opening on the quick link looks pretty small, I haven’t gotten the rope yet, want to make sure, also the edges on the opening.. do u guys file it down carefully? mine came very sharp
The only options they had were stainless and the other finishes so it would be my fault, for assuming.9 mm delta link works fine with 9 mm rope, 8 mm delta link works but it is a tight
i ordered a 10 mm delta link and they increase all dimensions at that threshold of size and it becomes a boat anchor
i use 9 mm delta links because they are a little heavier than 8 mm delta links but stronger with a bigger opening and the bend radius of the rope going around the 9 mm is a little less severe....it is the sweet spot for me
The only options they had were stainless and the other finishes so it would be my fault, for assuming.
I saw someone using a wire chip clip / paper clamp / clothespin thing that I want to try. If I girth hitch it to my pulldown line a foot or so in from the attachment to the rap line it should pop off if I forget to remove it. And I won't loose it (maybe).Finally, someone is going to join Team Chip Clip...