John RB
Well-Known Member
If you like heat shrink and square knots, I support your decision. I haven't tested it but it should work. I have had a few heat shrink ends pull off the ends of RescTech and Oplux though, due to the fact that the core and sheath are not bonded. Thats the reason i showed it on the milked sheath only. And so if you can get an inch or so of sheath milked off the core, that might be best. As for me, the design in the video is what I have been rigging with and I do prefer it for reasons cited already. CheersThe heat shrink is smooth and you could pull it through the ring, and you could tie a small simple square knot with paracord to pull it through. If anything, those prusik hitches on the end of the rope would hang up worse than either of these other two ideas
Sent from my SM-G975U using Tapatalk