Ok Hopefully I can type this out with confusing myself so bare with me....
I've been working really hard on my form. Particularly my anchor points and Back Tension. In doing so my draw length has increased making my current arrow set up Way Too Weak and too short with broadheads. Currently those arrows are Carbon Express Heritage 250 with Ethics 100g insert/ballistic collar and 200 grain field point. I went as far as putting the original insert (13g) back in with 100g field point and still too weak.
I have a full length Carbon Express Heritage 350 that bare shafts almost perfect. But it too is a little weak and I can't cut them any because my broadhead hits the belly of the bow and comes un-nocked. Was using Ethics 100g insert/ballistic collar and 200 grain field point. Don't really want to go any lower than that. If I do I'll have to change broadhead weights etc. Which I will do if that's my only option.
I also have a full length Gold Tip Traditional Classic XT with 1/2" (80g) insert/outsert with ballistic collar. It too was just a little weak with a 200g field point but just a little too stiff with a 150g field point. So with the added 1/2" from the insert/outsert I cut off 1/2"in. Sometimes it shows weak....sometimes it shows stiff with the 200g field point. It's pretty darn close and I know this is all because my form sucks/inconsistent and I'm still working on it. But would you guys call it good? or try a different shaft in a 300 Spine? I mean at this point it can't hurt to try I guess.
I will add that I've also played with Brace height. Everything from 7" to 7 3/4". 7 3/8" seems to the sweet spot. Just looking for some guidance and suggestions.
Bow set up is.....
60" Zipper SXT 49# @ 28"
Draw length is now 30 1/2" measured to belly of bow and with proper back tension.
I've been working really hard on my form. Particularly my anchor points and Back Tension. In doing so my draw length has increased making my current arrow set up Way Too Weak and too short with broadheads. Currently those arrows are Carbon Express Heritage 250 with Ethics 100g insert/ballistic collar and 200 grain field point. I went as far as putting the original insert (13g) back in with 100g field point and still too weak.
I have a full length Carbon Express Heritage 350 that bare shafts almost perfect. But it too is a little weak and I can't cut them any because my broadhead hits the belly of the bow and comes un-nocked. Was using Ethics 100g insert/ballistic collar and 200 grain field point. Don't really want to go any lower than that. If I do I'll have to change broadhead weights etc. Which I will do if that's my only option.
I also have a full length Gold Tip Traditional Classic XT with 1/2" (80g) insert/outsert with ballistic collar. It too was just a little weak with a 200g field point but just a little too stiff with a 150g field point. So with the added 1/2" from the insert/outsert I cut off 1/2"in. Sometimes it shows weak....sometimes it shows stiff with the 200g field point. It's pretty darn close and I know this is all because my form sucks/inconsistent and I'm still working on it. But would you guys call it good? or try a different shaft in a 300 Spine? I mean at this point it can't hurt to try I guess.
I will add that I've also played with Brace height. Everything from 7" to 7 3/4". 7 3/8" seems to the sweet spot. Just looking for some guidance and suggestions.
Bow set up is.....
60" Zipper SXT 49# @ 28"
Draw length is now 30 1/2" measured to belly of bow and with proper back tension.