DIY carbon camera arm

[BCHunter]

I think I've made something even @DaveT1963 would approve of to replace my fourth arrow camera arm. To be fair it's the all aluminum stiff arm, so it is a little heavier.

Sent from my moto z3 using Tapatalk

 

[Tapeworm]

Looks good to me


Sent from my iPhone using Tapatalk

 

[DaveT1963]

it's the tree bracket I hate

 

[BCHunter]

it's the tree bracket I hate

Haha, I'm getting to that, sadly some of the pieces I need are on a boat. I believe my whole setup will be under 2lbs and very adjustable.

Sent from my moto z3 using Tapatalk

 

[Boomah21]

Nice! More info! Parts, build instructions etc

Great job

 

[BCHunter]

Nice! More info! Parts, build instructions etc

Great job

I wish it was easier... The 7/8ths pvc should technically squeeze inside the carbon.... It doesn't, so I had to scrape it down and cut 4 pieces at 1.5". I drilled a 1" whole into a black HDPE block and cut it up for the washers and tripod head mount. 3/8ths aluminum rod just pressed into the pvc for the swivel. And a 3/8-16 Allen set screw jb welded in for the video head. Make sense? Let me know if you want close up or have questions.

25mm Carbon Fiber Tube 25mmx22mmx330mm 3K roll Wrapped Twill Matte Surface(2 pcs) https://www.amazon.com/dp/B07BCYFRKR/ref=cm_sw_r_cp_apa_YIESBbMFXEV28

PVC (Polyvinyl Chloride)... https://www.amazon.com/dp/B0013HQ93Q?ref=yo_pop_ma_swf

 

[ImThere]

Instructables? In the near future? Lol


Sent from my iPhone using Tapatalk

 

[BCHunter]

Instructables? In the near future? Lol

Sent from my iPhone using Tapatalk

Nah, I'm just going to do like @Erniepower and build some kits then start a company to sell them