Good enough! Heading to the classified section to see if I can find a few to mess with.
I have a fairly similar arrow setup and love it.
- RIP TKO Elite
- AAE Max Stealth set up with a left helical
- AAE IP #5 (don’t like lighted nocks)
- IW 50gr insert
- IW Ti 10gr collar
- IW SBL 100
One thing I found to work better for me personally was gluing the entire head and insert in as a single piece rather than setting the insert and then screwing the broadhead in. I struggled a bit with the HIT tool getting it seated to the right depth and couldn’t get my broadheads indexed the way I wanted them.
My process is is basically:
- Prep shaft
- Screw head into insert
- Heat up with heat gun
- Roll in blue glue
- Insert and index
- Wipe off excess
- Let it cool
If you need to change something I will heat up some water, dip the front of the arrow in and pull the whole assembly out. Zero issues with broadheads pulling out even on the toughest/most dense targets. Indexing and getting them to spin true is way easier for me this way.