Ez press dimension

[Chad8489]

I’m trying to find the thickness of the metal piece between the press fingers. The rod that allows you to set the width of the fingers goes through it. I’m reworking my press to accommodate higher poundage bows. Any help would be appreciated!

 

[KYhunter66]

I’m trying to find the thickness of the metal piece between the press fingers. The rod that allows you to set the width of the fingers goes through it. I’m reworking my press to accommodate higher poundage bows. Any help would be appreciated!

I will check I think it's about 3/4 wide 1/8 thick

 

[Loucamp]

7/8" diameter x 5/8" thick (wide)

 

[Chad8489]

You guys are awesome! Thank you! It almost looks like a sleeve welded on to the arm. That might be easier than the route I was going

 

[thedutchtouch]

You guys are awesome! Thank you! It almost looks like a sleeve welded on to the arm. That might be easier than the route I was going

100% that's what it is. You can see the welds here

 

[Chad8489]

100% that's what it is. You can see the welds here

View attachment 88646View attachment 88647

Perfect. Thank you!