valerio024
Well-Known Member
So I went to modify my heliums and I can’t decide where to cut them off. They seem to set up most naturally (due to the cut outs) for a 22” length with 19.5 between steps or a 26” length with 24“ between steps. I was hoping for about a 23” spacing. I can get there If I try to squeeze both the steps and standoff into one solid section. However it leaves the steps close to the slots. In the picture I would drill the dots not the x’s.
I guess I am left with two questions. How close can I drill to the slots? If I cut through the slots to lengthen it some I could lower the step holes. Is it fine to cut it for length through the slots?
Sent from my iPhone using Tapatalk
I guess I am left with two questions. How close can I drill to the slots? If I cut through the slots to lengthen it some I could lower the step holes. Is it fine to cut it for length through the slots?
Sent from my iPhone using Tapatalk