Midwest Hunter
Active Member
- Joined
- Nov 2, 2020
- Messages
- 133
Okay so I switched it up on the sticks I found a better way. On the stopper bolt I cut it down and nutted it from inside the post instead so you can put the steps completely vertical. By doing that you can stack them one up one down in line and then drill a bolt hole through them all to secure them or use a gear tie. If you go bolt and wing nut make sure your measurements are every from both ends of the sticks so you don’t have to mark them 1 2 3 4 to stack them in order and align the holes
I’ve been using the gear tie and think it’s an amazing way to secure them. Way better than the belt and clip that comes standard.
Sent from my iPhone using Tapatalk