Weisman125
Member
Need some advice from someone smarter than me. I've got an Elite Hunter that shoots bare shaft bullet holes through paper with the center shot at about 1 1/8". Anyone else have this issue? My QAD is maxed out. What could the problem be?
It's a 28.5" draw at 69lbs. It does this with 29" axis 5mm 340s with 125/100 grain heads and 28" axis 5mm 300s with 75 and 50 gr brass inserts and 125/100 gr heads. Online calculators say the spine should be correct. My 29" axis 400s shot a slight knock left tear. I've tried everything I can think of to correct this. I've played with cable slide bar to see if cam lean is an issue and it hasn't changed much. I've tried a rubber full hand grip (like old Mathews style) and tried different releases to see if something I'm doing with grip or release affects it with negligible change. Only thing I haven't done is replace the string. Could it be that simple. What else should I try?
It's a 28.5" draw at 69lbs. It does this with 29" axis 5mm 340s with 125/100 grain heads and 28" axis 5mm 300s with 75 and 50 gr brass inserts and 125/100 gr heads. Online calculators say the spine should be correct. My 29" axis 400s shot a slight knock left tear. I've tried everything I can think of to correct this. I've played with cable slide bar to see if cam lean is an issue and it hasn't changed much. I've tried a rubber full hand grip (like old Mathews style) and tried different releases to see if something I'm doing with grip or release affects it with negligible change. Only thing I haven't done is replace the string. Could it be that simple. What else should I try?