INbowHunter
Member
- Joined
- Nov 27, 2021
- Messages
- 41
I just finished up my first set of knaider/swaiders. This was my first time making anything that will be holding my weight/life saving equipment. Tested it out at ground level and feels super solid. Posting pics here to see if the guys who make a lot of weight bearing equipment saw anything that is concerning as far as stitching. I figured a knaider/swaider was a good warm up before jumping into a saddle build. Build info below.
1" MIL W 5625 Tubular Nylon Webbing-4000 lb BS
Austrialpin Frame Buckle -15KN
Rubber Coated J-Hooks from EWO
PremoBond Tex 90 UV Bonded Polyster Thread- Tensile Strength 13.3 lbs
SPI: 8
1" MIL W 5625 Tubular Nylon Webbing-4000 lb BS
Austrialpin Frame Buckle -15KN
Rubber Coated J-Hooks from EWO
PremoBond Tex 90 UV Bonded Polyster Thread- Tensile Strength 13.3 lbs
SPI: 8