Joedirt199
Member
- Joined
- Aug 14, 2020
- Messages
- 66
I trimmed both and still broke a male end off. I think the plastic/rubber is just too hard to work properly. I am going to trim down the door stopper method so they nest tighter.
Not sure I'm familiar with the "door stopper method". I read this entire thread so apologies if it was mentioned and I missed it but could you elaborate on what that method is?I trimmed both and still broke a male end off. I think the plastic/rubber is just too hard to work properly. I am going to trim down the door stopper method so they nest tighter.
I have some older 30" and the rubber is much more pliant and flexible than the newer 20" i bought this spring. I tried sanding,trimming, and ended up taking the male end off, removed the screw and plugged it into the female to create a height that allowed it to stack level with the tie off button and just strapped them together with bungees.
There is also this:
Suction Cups (JR 10665)
Suction cup and post hardware for attaching sticks together or for attaching sticks to platforms. DIY version of the 2019 Hawk Helium attachment method.doublesteps.com
Mentioned in this video:
Did the JR door suction cups yesterday. Used 2 for 3 fullsize sticks, middle stick has both parts placed opposite each other, one less screw to deal with. They do space the sticks further apart from each other so I used the old suction cup parts on the ends to keep the tips from banging together. Two sticks face the same way and the third cleats face toward the inside to keep the feet from sticking out so far. Still needed some silicone grease on the rubber cup as they stick pretty tight and make a pop when they come apart.