mike7tcu
Member
- Joined
- May 27, 2020
- Messages
- 94
Most likely is 1/2 28 but it’s hard to tell from the picture. You have to remember that the threads aren’t cut with a die. So when the gunsmith was threading your barrel for the break he would of just kept chasing your threads till the break screwed on with very little tolerance. So more than likely the threads in your thread protector are too deep for the threads in the barrel. Basically what I’m trying to say is if you go to the hardware store and buy a 1/2 28 nut they have to make it with enough tolerance to thread onto any 1/2 28 bolt this isn’t the case when your machining something like the break or barrel.