Did you need to cut out ware the steps go to fit ??
I did not. I put on stealth strips and then cut open the bolt holes. When I started tightening the nut it sucked the step down. It is a snug fit. Just as you tighten make sure the step is lined up
It does look cool, but I wasn’t going thru all that work. Lol. I used an old swhacker broad head to cut the holes. Worked well.Same for me, very snug. When you cut the places for the bolts you can heat up an exacto knife with a blow torch and it cuts a nice clean hole like butter. Melts the edges too, which seems like it will prevent them from peeling back with wear and tear.
I actually cut all the holes out this way. I could lie and say it was for weight savings or some other functional benefit, but honestly I just did it because it looks cool haha!
Sent from my iPhone using Tapatalk
Does that top step dig into your neck or Back when walking?