Predator, and I didn’t mean to like your post lol, darn carpel tunnelIs this on the Predator or Predator XL?
Some yes, some no. Because of their origin and some of the larger saddle personalities being associated with them, they’re very polarizing. I’m thankful for what they’ve done well and put off by what they haven’t.Do you not think it is deserved?
Thats what I'D say!Mine arrived with a hair crack in the same spot. The response from Tethrd was that they had a bad lot and thought they found all the defective ones.
Mine arrived with a hair crack in the same spot. The response from Tethrd was that they had a bad lot and thought they found all the defective ones.
Im on 5 hunts with mine. Im a big dude and weigh in at 255. Just inspected mine and it looks fine. Just and FYI.
The difference appears to be your adjustment screw hole is more in the center and mine is closer to the bottom. You see that? Hmm.....
Sent from my iPad using Tapatalk
I have seen this as well.I’m not gonna tell someone how to spend their hard earned money but after the Gen 1 fiasco there’s no way I’d be giving them my money. If the platform said “HAWK” you’d have 10 pages of people ****ing on it before noon tomorrow. Best of luck though, I’m sure they’ll send you another one.
The "not catastrophic" failure seems like the same response everyone had about the issues with the GEN 1. Mention a "recall" and you're accused of putting some good 'ol boys out of business.I know it doesn't mean much and I don't even use any of Tetherd's stuff but I don't think the spot they cracked would have ended up with catastrophic results like you ending up on the ground. Still definitely needs to be addressed though and I probably would be p*ssed if it happened to me after shelling out that kind of cash.
So what happened with the Gen1 Platforms?I have seen this as well.
I didn't explain enough. I meant I have seen people apologize all over for Tethryd but criticize others for the same type of things. I only know about Gen 1 platforms what I have read here. Apparently some of those cracked.So what happened with the Gen1 Platforms?
I didn't explain enough. I meant I have seen people apologize all over for Tethryd but criticize others for the same type of things. I only know about Gen 1 platforms what I have read here. Apparently they cracked.
I suspect that number is a casting date code. I also believe the threaded hole would be drilled and tapped in a secondary operation after casting. The positional offset would likely be due to a poor setup run.Also the casting number on mine is a 5 digit. 102920 vs what looks like a 10920.
ETA: Yep looks like mine is centered much batter then the cracked 2. Possible there was a production change. Looks like a different mold based on casting numbers.
Absoulutely. As long as they send a good product in the end they are good. Every manufactured item has some defects.Got it. Im not one to brand leg hump or poop on any one product. So far I have been happy with their products. The real tell is how they take care of things in the end. I hope they take care of it. Based on the pictures I am going to say we know what the cause of the crack it. A simple enhancment would be to drill the threads out and put a larger spacer on the bolt. This would take the stresses from sharp cut threads in a cast housing and load the face of the casting over a larger area.
I would love to see a machined or water jet cut platform. Not sure what that would do to the cost, do know what that would do to the strength.