Hey everybody. I've been sitting on this for awhile but figured I would just put it out there. This is a saddle I've been working on for a few months now. The concept being the additional bridge loop sewn into the vertical two inch webbing helps relieve the pressure of the main two inch webbing support. From my personal experience, there is a noticeable difference in comfort between this design and a traditional single panel saddle. I've been hesitant to pursue manufacturing of this saddle for a couple of reasons, liability being the main. Also, the startup cost for a one man operation are significant. With that said, I would love any feedback i could get from this site. Questions, concerns, interest, anything would help me in possibly pursuing this endeavor further.
Sent from my SM-G960U using Tapatalk
Sent from my SM-G960U using Tapatalk