- Joined
- Sep 1, 2020
- Messages
- 1,976
Well, the speed question is only one that you can answer. There is an advantage of going over 19% FOC from the data. You're only losing like 13 fps by going form a 100 to 200 grain point. If you are getting perfect arrow flight out of that then that would be a good place to start. You can always go heavier.So I got a field point test kit and shot these tips. What say ye? When is the speed to slow?
FOC if one of the two must be lacking. But make sure you get perfect arrow flight and structural integrity, #'s 1 and 2. I would start with that 200 grain point and go from there, you might end up higher or lower weight to get perfect flight but if I had too I would err on the side of higher weight if possible.In the report FOC is #3 and total weight is #12 so which one should I choose from the list. Next step is to paper shoot all the weights?
i agree with this. thats the sweet spot in your data if it shoots good.Looks like a 200 grain point will get you above 19% with very little loss of speed.
What do you mean when you say #3 and #12 cooter? i havent read through all the posts i think i missed something
Yes that's it. Thanks for clearing that up12 Arrow Penetration Factors — Ashby Bowhunting Foundation
www.ashbybowhunting.org
you can just bareshaft tune at a target if you know your bow is shooting good. Just make sure you're standing in the exact same spot each shot. RF has some really good videos on all that stuff.Is paper shooting the best way to assess arrow flight? No fletching or fletched?
Did you say louder because unless I misunderstood most people were saying their bow and arrow flight is quieter the higher the total weight (slower shaft speed)?gotcha. I would say FOC is going to be more important than TAW. you can really change things by switching out your fletchings if you want more. Its a lot of work but you're going to bareshaft tune and all that anyways. 550ish is what i shoot now. I shot 660 when i first dove into it and i think i like the way my setup shoots now. def louder but way more forgiving if i aim a little short.
just dont try it bareshaft with a broadhead haha. woops!you can just bareshaft tune at a target if you know your bow is shooting good. Just make sure you're standing in the exact same spot each shot. RF has some really good videos on all that stuff.
The arrow is quiter too but the bow was much much quieter. I am more inclined to think the bow sound isnt as important as the arrow sound now though. If i clap a deer wont usually duck. they just look up at me. if an arrow is going at them theyll try and duck it somehow. Someone on here explained that to me actually and it definitely changed my mindDid you say louder because unless I misunderstood most people were saying there bow and arrow flight is quieter the higher the total weight (slower shaft speed)?
I misread your post sorry.The arrow is quiter too but the bow was much much quieter. I am more inclined to think the bow sound isnt as important as the arrow sound now though. If i clap a deer wont usually duck. they just look up at me. if an arrow is going at them theyll try and duck it somehow. Someone on here explained that to me actually and it definitely changed my mind
Is paper shooting the best way to assess arrow flight? No fletching or fletched?