Tom Karrow
Active Member
Thank you.. where can I get these? They are standard diameter under that name?Beal jammy is a very high rated prusik loop. Size is perfect for the 8mm oplux
Thank you.. where can I get these? They are standard diameter under that name?Beal jammy is a very high rated prusik loop. Size is perfect for the 8mm oplux
This is 35 ft with figure 8 for rappelling, a 7 ft linesman and 7 ft tether with figure 8s, 3 caribiners, Ropeman 1, and a Madrock Safeguard in there together. Oh yea, and a sewn loop tubular tether with an Austrialpin release buckle. Didn't put them in, but my knaider/swaider will also fit on top. This Oplux is truly awesome! The ES will hold even more.
Sent from my SM-N970U using Tapatalk
If no one else posts, I'll do a comparison when my next order arrives in a day or two.
how long did you order the 8mm pieces for tether and LMB?I ordered. 60 cm jammy as I was unsure how long a length I needed. It was more than enough to cut the sewn ends off and make a distel hitch with. I cut off a DanO tender and used it for tending.
This is way smaller in weight and volume than 11mm and 8mm. See my thread about oplux and no kong duck for some more pics.
@Oakridge , could you repost this pic? For some reason it's not showing up anymore. Thanks!
how long did you order the 8mm pieces for tether and LMB?
Is beal jammy material available in bulk and in other colours? I looked through the beal website but could not determine the exact material they use in the jammy??
Thanks
@Squirrels what length of jammy are you using for the autoblock?Descending/rappel is a 36’ OpLux, Madrock Safeguard, a Beal jammy as an autoblock backup. Yes the OpLux is out of spec of the Safeguard.
www.doublesteps.comThank you.. where can I get these? They are standard diameter under that name?
The shortest one. The others would be to long I think. I do like the 50 or 60 for a friction hitch on a tether or LB, cut of the stitched section and tie it in a distel as tight as possible (without a lot of extra hanging below the hitch) easier to tend that way.@Squirrels what length of jammy are you using for the autoblock?
This is 35 ft with figure 8 for rappelling, a 7 ft linesman and 7 ft tether with figure 8s, 3 caribiners, Ropeman 1, and a Madrock Safeguard in there together. Oh yea, and a sewn loop tubular tether with an Austrialpin release buckle. Didn't put them in, but my knaider/swaider will also fit on top. This Oplux is truly awesome! The ES will hold even more.
Sent from my SM-N970U using Tapatalk