huntin_addict
Well-Known Member
My new post was delivered today and is installed. Tolerances on the holes are pretty tight, so much so that I had to run a 1/4" drill bit down thru the holes for the bolt for the leveler. The paint was causing the bolt to not free float which is important for the leveler to function correctly. Additionally, there is a milled slot where the versa button goes that is smaller on the new post. Because of this, I was unable to use the DanO Alumibutton I had on it, have to use the steel replacement versa button LWCG had sent a while ago.
When I took it apart it was evident how bad the last post was. There are shims on each side of the post. One was fine, the other had been drilled out and the hole is significantly elongated.
Will get this on a tree this weekend.
When I took it apart it was evident how bad the last post was. There are shims on each side of the post. One was fine, the other had been drilled out and the hole is significantly elongated.
Will get this on a tree this weekend.